Chemical

As far as direction is concerned, Flight Works pumps will work equally well oriented in any direction (even upside down). However, there are a few helpful tips to consider when mounting the pump:

• If possible, using something to dampen vibration can help increase the life and reliability of the pump. Rubber grommets in a bracket, a mounting pad, or similar methods will help keep system vibration from disrupting the pump in any way.
• When used in a system that will be outdoors, it is best to mount the pump in a more protected location within the system, as exposure to the elements can cause issues with certain configurations.
• When mounting a magnetic drive pump, be sure not to place the magnetic coupling section too close to aluminum or other materials that can cause eddy currents. Also, if you expect any g-force loads, mounting the pump perpendicular to the direction of those loads is ideal.

Oftentimes, a pump can struggle to prime, or can create cavitation, if there is small air leak in the system. Check that any fittings, valves, tubing, etc. are all sealed and firmly in place. It may be necessary to tighten fittings or use a pipe thread tape to help prevent air from entering the system.

Filtration is extremely important when using Flight Works micro gear pumps, as the components and clearances are extremely small and minuscule particulates can cause damage if not properly filtered. A filter with a 25-50 micron rating or better should be installed before the pump (the finer the better). In closed-loop systems, installing a filter after the pump can also be beneficial, as it will prevent any “break-in” period from contaminating the system.

Each Flight Works pump has been configured with materials deemed compatible with the customer’s primary fluid. Whether it can be used with any other fluids may depend on the configuration and the alternate fluid. Contact Flight Works to confirm compatibility before using any additional fluids.

First you should have either a brushless speed controller sold by Flight Works or an equivalent method of control in your system. After that most of the information you need can be found in our Brushless Control Instructions

Flight Works pumps are capable of “dry priming” which means they can draw fluid without being pre-filled. However, the pump should not operate dry for more than 30-60 seconds, as this can damage the internal components.